It should be noted here that if you want to empty the oil in the oil tank of the DC geared motor, you need to open the oil drain plug at the lower part of the oil tank to drain the oil.You should know that in a DC geared motor, when the oil is drained outside, the height of the oil level and the top plate of the fuel tank cannot exceed 30 mm.The purpose of this requirement is also to ensure the lubrication and cooling effect of each bearing in the DC geared motor.
After the first 500 hours of operation, the variable speed hydraulic DC gear motor needs to change the oil and clean the oil tank of the equipment, because we need to test the quality of the used oil.If the oil is found to be of poor quality, it needs to be replaced in time.During the oil change process, the oil tank and oil filter of the DC geared motor need to be cleaned at the same time.If metal fragments or water are found in this process, it is necessary to find out the problem and solve the cause as soon as possible.
XINLAN motorLook for it: Zibo XINLAN Zeyu Motor Factory provides selection guidance, principle and parameter introduction, complete models and reasonable prices for DC speed motors and planetary gear motors.