Maintenance method of DC geared motor

　　Routine maintenance of the equipment is very important. When the DC geared motor equipment is used for a long time, some failures will occur.If proper maintenance can be carried out, it can not only reflect its use effect, but also save part of the maintenance cost during use.

　　1. The first is to protect the appearance of the DC geared motor: clean the outer surface and cover of the lathe, keep the inside and outside clean, free of rust and oil, clean the three rods, and check and complete all screws, handle balls and handles.After cleaning and wiping, all parts should be lubricated as needed.
　　2. Electrical maintenance: clean the dust on the motor and electrical box.And the electrical installations should be fixed and tidy.
　　3. Maintenance of the exchange gearbox of the DC reduction motor: clean the gear and the shaft sleeve, and inject new grease into the oil cup.Adjust the gear meshing gap and check whether the shaft sleeve is shaken.
　　4. Maintenance of the lubrication system 1 of the DC geared motor: clean the filter and the liquid tray to ensure that the oil path is smooth, and the oil holes, wicks and linoleum are clean and free of debris.Then check the oil quality and keep it in good condition.The oil cup is complete and the oil mark is clear.
　　5. Maintenance of DC geared motor slide plate and knife holder: disassemble and clean the knife holder, medium and small slide plate, clean and dry them, then reassemble them, and adjust the gap between the medium and small slide plate and the insert bar.
　　6. Maintenance of the tailstock: Shake out the tailstock sleeve, wipe and apply oil to keep the inside and outside clean.
　　It is very important to take protective measures for the DC geared motor, so as to ensure the equipment has a long service life and good use effect.Through the above brief introduction to this device, I hope it can be helpful to you.