Capacity
All power take-offs are particularly designed for generating hydraulic pumps to SAE J744C series ‘B’ specification with splined insight shaft and either two-bolt or four-bolt fixing. The maximum power which may be transmitted can be 22 KW (29.5 bhp) per 1000 rev/min engine speed; this compatible a torque of 209 Nm (155 Ibf.ft. – 21.33 kgm.).For PRM1000 the clutched power take-off provides pump rotation the same as the engine, where as the direct drive power take-off for the PRM500 and PRM750 will give opposite rotation. Capacity to the pump isn’t affected by the standard utilization of the gearbox for propulsion duties. All ancillary power circuits driven by PRM power take-offs ought to be designed relative to the suggestions of the hydraulic tools manufacturer, and should be correctly safeguarded against overloading.
Installation
PRM power take-off models fit on the rear face of the primary gearcase and so are driven by the input shaft; consequently they could be operated all the time whilst the engine is definitely running, The energy take-off replaces the end cover which is generally fitted and performs the functions of the finish cover by sealing the gearbox against lack of oil and correctly positions the insight shaft back bearing. Power take-off devices provide the link between your gearbox and the hydraulic pump.

Direct Drive Power Take-Off
On the PRM500 and PRM 750 the direct drive power take-off is certainly driven directly from the gearbox input shaft; consequently it will operate at all times when the engine is certainly working, and since there is absolutely no clutch for disengagement of the hydraulic pump, provision should be made in the auxiliary hydraulics circuits for pressure by-pass to the reservoir when power to the pump is not needed. A set of 1:1 ratio gears, providing enough offset between your gearbox result shaft and the centreline of the power take-off to ensure there is adequate clearance between the hydraulic pump and propeller shaft coupling.

Specifications
Ever-Power PTO Shaft
Series 6
1-3/8 inch 6-spline tractor end yoke and a 1-3/8 inch 6-spline FD2 clutch on the implement end
FD2 clutch
Collapsed length: 47 in.
Extended length: 60 in.
62 HP at 540 RPM
98 HP at 1000 RPM
FD2 clutch attaches with one bolt that suits a groove on insight shaft of rotary mower

Below are few even more write-ups associated to pto gearbox which might interest you.