RV worm gear reducer

The input type of RV worm gear reducer is divided into four types: hole input, shaft input, shaft input with extension, and flange input with extension. The output form is divided into four types: hole output, one-way shaft output, two-way shaft output, and flange output. . F...(1-2) With output flange. VS is equipped with the same direction input shaft. AS is equipped with a one-way output shaft.
RV worm gear reducer instruction manual:
When the RV worm gear reducer is working outdoors, it is necessary to take sun protection, anti-collision and rain protection measures.
The RV worm gear reducer should be placed on a flat or rigid supporting surface and avoid all foreseeable vibrations around it. It is recommended to pre-tighten the anchor bolts with washers.
Enough lubricating oil should be kept in the RV worm gear reducer case and checked regularly.
The RV worm gear reducer series are of ordinary design and are used in occasions where the ambient temperature does not exceed +40°C. When a pinion, coupling or belt wheel is installed on the output shaft end of the RV worm gear reducer, the screw hole press-in method at the shaft end must be used, and hammering is strictly prohibited.The mixed use of synthetic oil and mineral oil should be avoided. The input speed of the worm should not exceed 1500r/min. The lubricating oil should be replaced after the first 150 hours of operation. The oil change interval is about 4000 hours after the test run is qualified.